HUUM GSM/ Wi-Fi/ Local Heater Control Console Ohjekirja

Brändi: HUUM

Malli: GSM/ Wi-Fi/ Local Heater Control Console

Tyyppi: Ohjekirja

UKU GSM/ Wi-Fi/ Local

HEATER CONTROL CONSOLE 3–15

ELEKTRIKERISE JUHTSEADE 17–29

SÄHKÖKIUKAAN OHJAUSKESKUS 31–43

STEUERKONSOLE 45–58

 59–73

BASTUAGGREGATETES STYRENHET 75–87

[email protected] www.huum.eu

UKU GSM/Wi-Fi/Local

HEATER CONTROL CONSOLE

Installation and User Instructions

NB! The electrical work described in this manual must be carried



The devices set contains:

• UKU control panel;

• 

• thermal sensor;

• door sensor;

• 

• 

NB! Keep this operating manual near the device so that at any time



BEFORE INSTALLATION

Before installation read the operation manual thoroughly This

way



prevent



• 

install the device.

• Installation and maintenance of the device is only allowed when it

is not under voltage.

• For unique problems that are not covered in the installation



• 

authorisation.

• The manufacturer has the right to make improvements to the

device. The latest version of the operation manual can be found



• Make sure that the building’s cables from the main switchboard







switchboard

to the sauna. Install

separate

protection for the heater.

• It is recommended to connect the unit to the mains without an

earth-leakage circuit breaker.

• This product is intended to operate with equipment that meets



Symbols used in the installation manual





UKU control panel

Main controller

Door sensor

Temperature sensor











SN SL LN LL L1 L2 L3 N N W V U

3/N ~ 400V

L1 L2

Min. 10 cm

Max. 40 cm

15-20 cm

Min. 50 cm

50 cm

2x 0,34mm2

SLSN

N L

LLLN

N L

1/N ~ 230V

L1L2L3N

1/N ~ 230V

L1N

10 cm

4x 0,34mm2

WARNING! Not following these instructions may lead to serious or fatal



CAUTION! Not following these instructions may lead to minor to semi-



NB! Also follow the special safety requirements given in the individual





INSTALLING UKU ELECTRICAL CONTROL

DEVICE

• Before installation disconnect the electric heater from the power

supply in the switchboard.

• The control device 1 must be installed outside the steam



manufacturer’s recommendations.

• If your main controller 2

supports the use of Wi-Fi or GSM

connec

tions

it must be

installed

where the appropriate

reception

available.

• The device must be installed in a dry place. The protection



• 



CAUTION! The control device must be connected to the mains







NB! Measure the lengths of the cables and determine the locations of



NB! When connecting the the control device with a singel phase make

sure the fuse where the power is coming from has the necessary





Control panel UKU 1

With a wooden housing

• Remove

the

back

cover

of UKU

control

panel



to the

wall

• 

control panel is at eye level.

• Connect the power cable with the screw terminal of the device.

• 

wall. Secure it with screws from the sides.

With a plastic housing

• Connect

the power cable with the cable screws of UKU

control

panel

• 

• 

• Replace the control knob to the control panel.

Main module 2

• 



• 

• 

sensor and door switch through a cable gland to the enclosure



• 



Door sensor 3

• T

• 

in the door frame.

• 



• Connect the cable ends to the terminals of the sensor.

• Secure the magnet to the door. It must allow the door to close

and pass directly by the doorpost.

• Secure the sensor to the doorpost so that when the door closes



the sensor and the magnet will be aligned. The maximum distance



door is closed.

Temperature sensor with overheating protection 4

• 

• 

• 



• 

• 



Vaporiser 6

• A vaporiser is connected to outputs SL SN as shown in the





instructions.

CAUTION! When connecting the control console with an electrical

heater with vaporiser function ensure that the water tank is always





Connection of a lighting system

• 





the control console.

• 



• 



Connecting the Wi-Fi controller to the network

• 





controller doesn’t support Wi-Fi names and passwords longer



• 



• 

• 

• 

• You

can

continue

to enter the password after selecting a Wi-Fi network.

• 



• 

Connecting the GSM controller to the network

• 

SIM card is activated. The SIM card and sauna will come online in





• 





not want the mobile app after the free year you don’t have to pay



Payment is made by credit card in the mobile app.

• 

UKU mobile app

The UKU Wi-Fi or GSM device can also be controlled by a smartphone

with a special mobile application in addition to the control panel. This

way you can put the sauna to work being far from home.

Download the HUUM application from the application page of your



• IOS – App Store;

• Android – Google Play;

• Web application - app.huum.eu

• Create a user account.

• 

ID number and code of the sauna are on the sticker of the main

module.

• Check whether all the functions of the mobile application are

working properly and your commands actually reach the sauna.







• An unlimited number of users can be connected to one sauna.

NB! In case the control console is not connected to the user account

in the mobile application, the sauna will not be connected with the



Upgrading the capacity of the Local remote control to the level

of Wi-Fi remote control



that converts UKU Local to UKU Wi-Fi. This update does not require a

technician to be called.

TESTING

NB! 

WARNING!



• Check the power terminals of the circuit breaker and main



from the switchboard on by using the circuit breaker. The screen



• Check the door switch: close the steam room’s door. Turn the

control console on. Set the temperature. Turn the heating on.

Contactors must switch on. Open the door. Contactors must switch





seconds

. Close the door.

Contactors

must switch on

again

• Check the temperature sensor:

• 

switchboard for quarter of minute and then on again. The





• 

time – therefore it may take some time to reach the actual

temperature reading.

• 

Check that desired temperature is maintained. Turn the



• Set the desired temperature. Turn the heating on. Check that

the temperature is achieved and maintained.

OPERATION MANUAL

• 



• 

temperature value.

• If the symbol 

connection has been turned on. The sauna will not be connected

to the network before it is connected to the app.

• The control console is connected to the network and ready for

 appears on the status line.

• The signal strength of the cellular network is indicated by the



• The screen is always active during heating.

• Using the sauna from the control panel you can choose between

heating times of 3, 6 hours for private saunas, 12 hours for

semi-public saunas and 18 hours for public saunas from the

seings menu.

choose the heating period.

• 



• The number displayed in the upper right corner of the screen is

the target temperature of the sauna. The current temperature is

displayed in the centre of the screen. Turn the knob to adjust the

temperature.

• 





• 

seconds.

• 



• 

With a simple heating 



With a smart algorithm

gradually one by one before the target temperature is reached.





heating elements

• 

appliance is connected to the LN LL outputs for the selected time



Child lock

• 

• The child lock will automatically turn on when the screen of the



• 



quarter

to the left and back to the beginning to activate the screen

Timer

• 

seconds.

• 





Lighting

• 

• 



Vaporiser

• 

• 





• Heat intensity is displayed as an indicator in the lower left corner



Using the mobile app

• Set the desired temperature for the sauna and heating time (the



• Turn the sauna on.

• More details are available in the application’s instructions.

GENERAL

SAFETY INFORMATION FOR THE USER

• -

dition and safety. If the heat sensor with overheating protection



• For unique problems that are not covered in the installation



• 

to alter or rebuild the device.

• The manufacturer has the right to make technical changes to the

device.

PURPOSEFUL USE

• Make sure that there are no objects on the heater. Even non-

combustible

items



resulting



• Close the steam room’s door for the time the sauna is heated.

Heating will not work with an open door.

• 



• This device is not intended to be used by people with limited





supervised by a person responsible for their safety or they have

received instructions from such a person.

• Ensure that children do not play with the device.

• 

sauna is not being used.

• 

remove any items from the heater. Make sure steam room is safe

and close the door.

• 

old devices into the household waste.

• 

not intend to use the sauna for an extended period.

WARRANTY TERMS FOR HUUM EQUIPMENT

• The warranty only applies to the product that has been installed

and used in accordance with the manual.

• 

considered as consumable parts.

• The warranty does not cover normal wear or improper use of the

product.

• 



• 

• damage or defects due to transport and or other actions not

controlled by manufacturer;

• 

overloading the product;

• errors in the installation of the product due to non-



or safety requirements;

• 



• product incompleteness;

• using together with products that are not compatible with

this device;

• when the product warranty period has expired.



UKU GSM/Wi-Fi/Local

ELEKTRIKERISE JUHTSEADE

Paigaldus- ja kasutusjuhend

NB! Käesolevas juhendis kirjeldatud elektritöid tohib teostada



Seadme komplekti kuulub:

• UKU kontrollpult;

• 

• termoandur;

• ukseandur;

• 

• 

NB! Hoidke seda paigaldus- ja kasutusjuhendit seadme läheduses, et

saaksite igal hetkel ohutusnõuandeid ja seadme kasutamiseks olulist



ENNE PAIGALDAMIST

Lugege kasutusjuhend enne seadme paigaldamist põhjalikult

läbi, et kasutada seadme kõiki eeliseid ning vältida kahjustuste

tekkimist



• Seadet võib paigaldada ainult elektrik või samaväärse



• 

ei ole pinge all.

• 

pöörduge ohutuse tagamiseks oma tarnija poole.

• Seadet ei ole lubatud omavoliliselt muuta või ümber ehitada.

• Tootjal on õigus teha seadmele täiustusi. Kõige viimase

kasutusjuhendi versiooni leiate tootja kodulehelt (

www.huum.ee



• 

asukohani oleks piisava ristlõikega. Vanema hoone korral pöörake

tähelepanu harutooside seisukorrale ning võimalusel vedage uus

juhe kilbist saunani. Paigaldage saunale eraldi voolukaitse.

• Soovitatav on seade ühendada vooluvõrku ilma rikkevoolu

kaitsmelülitita.

• 



Joonis ja selle olulised detailid

Juhendis on värviliste numbritega tähistatud järgnevad sauna



UKU kontrollpult;

Peamoodul;

Ukseandur;

Termoandur;

Keris ;

Auruti ;

Valgusti ;





SN SL LN LL L1 L2 L3 N N W V U

3/N ~ 400V

L1 L2

Min. 10 cm

Max. 40 cm

15-20 cm

Min. 50 cm

50 cm

2x 0,34mm2

SLSN

N L

LLLN

N L

1/N ~ 230V

L1L2L3N

1/N ~ 230V

L1N

10 cm

4x 0,34mm2

Paigaldusjuhendis kasutatud ohutusnõuanded

HOIATUS! 



ETTEVAATUST! 



NB!

PEAMOODULI PAIGALDAMINE

• Enne seadmete paigaldamist katkestage elektrikilbist elektri-

kerise toitevool.

• Kontrollpult 1

silmade kõrgusele ukse kõrvale või vastavalt leiliruumi tootja

soovitustele.

• Kui teie peamoodul 2



• Peamoodul tuleb paigaldada kuiva kohta. Seade vastab klassile



• 



HOIATUS! Peamoodul tuleb ühendada vooluvõrku püsivalt, kasutamata





NB! Mõõtke välja kaablite pikkused ja määrake kaablite ja seadmeosade



NB! Ühendades peamoodulit ühe faasiga kontrollige, et kaitse, mille





Sivu latautuu ...

HUUM GSM/ Wi-Fi/ Local Heater Control Console Ohjekirja

Brändi: HUUM

Malli: GSM/ Wi-Fi/ Local Heater Control Console

Tyyppi: Ohjekirja

Lataa PDF

raportti

HUUM GSM/ Wi-Fi/ Local Heater Control Console Ohjekirja

HUUM GSM/ Wi-Fi/ Local Heater Control Console Ohjekirja

muilla kielillä

Muut asiakirjat