- 4 -
To switch within a measurement system,
g/kg - ml water - ml milk
or
oz/lb:oz - fl´oz water - fl´oz milk
briefly press the sensor area UNIT
u
until the
desired measurement unit appears in the display
e
.
Weighing
Press the sensor area ON/OFF
t
to switch the
scales on (weighing mode).
Programme in the desired measurement unit
(see chapter "Setting the units of measurement").
The scales indicate a weight of "0". In the left of the
display
e
a "O" is indicated.
Place a suitable receptacle on the scales and
press the sensor area Z/T
y
. The scales once
again show "0", it does not take account of the
weight of the receptacle.
Place the item(s) to be weighed in the receptacle.
Adding & Weighing (Tare Function)
You can repeatedly set the scale back to "0" in order
to weigh additional partial quantities.
Press the sensor area Z/T
y
once. In the left of
the display
e
appears „TARE“. The scales indi-
cate a weight of "0" again.
Place the additional item(s) to be weighed in the
receptacle.
The weight of the newly inserted item(s) is shown in
the display
e
.
You can repeat this procedure several times.
However, never place more than 5 kg on the
scale.
When you take all of the weighed items from the
scales and press on the sensor area Z/T
y
,
"O" is indicated in the left of the display
e
.
Removing Weighed Items
Press the sensor area Z/T
y
once. "TARE" is
indicated in the left of the display
e
.
The scales indicate a weight of "0" again.
Remove the desired amount of material.
The weight value of the removed material appears
in the display
e
as a negative value.
You can repeat this procedure several times.
When you take all of the weighed items from the
scales and press on the sensor area Z/T
y
,
"O" is indicated in the left of the display
e
.
Setting the Timer
The timer can be used in both a clock and weighing
mode.
The timer enables you to set the clock for a specific
period of time, at the end of which a signal tone
sounds. The preset time runs as in a countdown
Press the sensor area T-SET
i
once. In the dis-
play
e
the bell symbol appears at above-
left.
You can adjust the time accurately to the second.
If you hold your finger on the sensor area
Z/T
y
or UNIT
u
, the time-indicators run
through faster.
Using the sensor areas Z/T
y
or UNIT
u
programme in the desired ten-minute setting.
Press the sensor area T-SET
i
once. Using the
sensor areas Z/T
y
or UNIT
u
programme
in the desired single-minute setting.
Press the sensor area T-SET
i
once. Using the
sensor areas Z/T
y
or UNIT
u
programme
in the desired ten-second setting.
Press the sensor area T-SET
i
once. Using the
sensor areas Z/T
y
or UNIT
u
programme
in the desired single-second setting.
Press the sensor area T-SET
i
to start the count-
down.
IB_KH1157_UI25719_LB3.qxd 26.11.2008 13:50 Uhr Seite 4